Lynx L15ICE Manual descargar pdf (Pagina 7)

II. Installation Instructions

A. Checks Before Installation

Visually inspect the exterior of the shipping container and report any severe damage to the carrier.

WARNING

Remove shipping tape(s) and packing as follows. If any are left in the icemaker, it will not work properly.

IMPORTANT

1. Remove shipping tape holding the door.

2. Ensure all components, fasteners and thumbscrews are securely in place.

• Remove the package containing accessories. Remove shipping tape holding the separator.

• Check that refrigerant lines do not rub or touch lines or other surfaces.

• Check that the compressor is snug on all mounting pads.

• Remove the protective plastic lm from the panels. If the icemaker is exposed to the sun or to heat,

remove the lm after the icemaker cools.

• See the nameplate on the rear panel, and check that your voltage supplied corresponds with the voltage

specied on the nameplate.

B. Location

1. General

WARNING

Normal operating ambient temperature should be within 45°F (7°C) to 100°F (38°C); Normal

operating water temperature should be within 45°F (7°C) to 95°F (35°C). Operation of the icemaker,

for extended periods, outside of these normal temperature ranges may aect production capacity.

For best operating results:

• The icemaker should not be located next to ovens, grills or other high heat producing equipment.

• The location should provide a rm foundation for the equipment. Level the icemaker from side to side

and front to rear.

• Avoid a site where dripping is not allowed.

• This icemaker will not work at subfreezing temperatures. To prevent damage to the water supply line,

drain the icemaker when air temperature is below freezing.

• This icemaker requires no clearance on either side. But allow enough space at rear for water supply and

drain connections and at least 15" (approx. 38 cm) clearance at front.

1 2 3 4 5 6 7 8 9 10 11 12 ... 19 20

Sin comentarios

Lynx L15ICE Manual Pagina 7