Lynx L15ICE Manual descargar pdf (Pagina 14)

4) Spread out the tabs on both sides of the water tank

to unlock it, then pull it out toward you. Drain

the tank.

5) After draining, slide in the water tank along the

rails at the bottom of the right and left brackets

until it clicks into place.

6) Ret the suction tube onto the water tank inlet

by pushing the joint to lock it securely in the

direction of the arrows. A loose tting may

cause a water leak.

7) Slowly pour the cleaning solution into the water tank.

8) Move the control switch to the "WASH" position.

9) After circulating the cleaning solution for about 30 minutes, move the control switch to the

"OFF" position.

10) Remove the water tank, drain it, and replace it as described in 3) through 6).

11) Open the water supply line shut-o valve.

3) Disconnect the suction tube by

compressing both plastic tabs to

unlock the joint in the direction of the

black arrows and pulling the tube clear.

2. Cleaning Procedure

The cleaning process will remove lime deposits from the water system.

1) Remove all ice from the evaporator and the storage bin.

Note: To remove cubes on the evaporator, move the control switch to the "OFF" position

and move it back to the "ICE" position after 3 minutes. The defrost cycle starts and

the cubes will be removed from the evaporator.

2) Move the control switch to the "OFF" position. Close the water supply line shut-o valve.

Unlock Unlock

Lock Lock

Bracket

Rail Rail

Water Tank

Joint Drain

Suction Tube

1 2 ... 9 10 11 12 13 14 15 16 17 18 19 20

Sin comentarios

Lynx L15ICE Manual Pagina 14