Lynx L15ICE Manual descargar pdf (Pagina 17)

13) Position and lock the ice chute onto the front

and rear frame pipes by pushing the chute

down until it clicks onto both pipes.

14) Slide in the water tank along the rails at the

bottom of the right and left brackets until it

clicks into place.

15) Ret the suction tube onto the water tank inlet

by pushing the joint to lock it securely in the

direction of the arrows. A loose tting may

cause a water leak.

16) Hook each separator onto the rail, and pull it

hard toward you until it locks in place with a

click. Ret all the separators in the same way.

17) Ret the slope in its correct position.

18) Close the water supply line shut-o valve.

19) Discard the sanitizing solution.

Lock Lock

Bracket

Rail Rail

20) Mix a new batch of the sanitizing solution and slowly pour it into the water tank.

21) Move the control switch to the "WASH" position.

22) After circulating the sanitizing solution for about 15 minutes, move the control switch to the

"OFF" position.

23) Disconnect the suction tube by compressing

both plastic tabs to unlock the joint in the

direction of the black arrows and pulling the

tube clear.

Water Tank

Joint Drain

Suction Tube

1 2 ... 12 13 14 15 16 17 18 19 20

Sin comentarios

Lynx L15ICE Manual Pagina 17