Lynx L15ICE Manual Pagina 16

  • Descarga
  • Añadir a mis manuales
  • Imprimir
  • Pagina
    / 20
  • Tabla de contenidos
  • MARCADORES
  • Valorado. / 5. Basado en revisión del cliente
Vista de pagina 15
16
7) Spread out the tabs on both sides to unlock
the water tank, and pull it out toward you.
Soak the water tank in the sanitizing solution
for 10 minutes.
Ice Chute
Frame Pipe
Unlock Unlock
8) Lift o the ice chute from the front frame pipe
and then from the rear frame pipe. Soak the
ice chute in the sanitizing solution for 10
minutes.
9) Pull the discharge tube from the spray
assembly. Remove the assembly by pulling it
toward you.
10) Remove the two caps. Soak the caps and the
spray assembly in the sanitizing solution for
10 minutes. If the nozzles are clogged, clean
them with a wire or a suitable brush.
11) Ret the two caps in their correct positions.
Make sure the reducing pipe is in place in the
center.
12) Slide in the spray assembly along the rails on
the right and left brackets. Ret the discharge
tube securely on the spray assembly. A loose
tting may cause a water leak.
Discharge
Tube
Spray
Assembly
Cap
Reducing Pipe
Frame Pipe
Bracket
Rail Rail
Vista de pagina 15
1 2 ... 11 12 13 14 15 16 17 18 19 20

Comentarios a estos manuales

Sin comentarios