Lynx L15ICE Manual descargar pdf (Pagina 15)

12) Move the control switch to the "WASH" position to circulate clean water for about

5 minutes.

13) Move the control switch to the "OFF" position, then remove the water tank, drain it, and

replace it as described in 3) through 6).

14) Repeat 12) and 13) three more times to rinse thoroughly.

3. Sanitizing Solution

Dilute 0.5 . oz. (14.8 ml or 1 tbs) of 5.25% sodium hypochlorite solution (chlorine bleach)

with 1 gallon (3.8 l) of warm water. Using a chlorine test strip or other method, conrm that

you have a concentration of about 200 ppm.

For safety and maximum eectiveness, use the solution immediately after dilution.

IMPORTANT

4. Sanitizing Procedure

The sanitizing process will sanitize the icemaker.

1) Move the control switch to the "OFF" position.

2) Open the bin door and remove ice from the storage bin.

3) Remove the slope by bending its center carefully and releasing it from the two slope

shafts. Remove the slope from the storage bin.

4) Thoroughly clean and sanitize the storage

bin, slope, scoop and any parts normally

accessible from the storage bin.

5) Remove each separator by lifting it to the

horizontal position and pushing it hard

inward. Remove all separators in the same

way and clean and sanitize them.

6) Disconnect the suction tube by

compressing both plastic tabs to unlock

the joint in the direction of the black

arrows and pulling the tube clear to drain

the tank.

Separator

Water Tank

Joint Drain

Suction Tube

1 2 ... 10 11 12 13 14 15 16 17 18 19 20

Sin comentarios

Lynx L15ICE Manual Pagina 15